Auto >> AutoSPT >  >> Engine

1984 ford bronco 2 starter grinding problems is there a thin plate between the engine and trans?

Yes, there is a thin plate between the engine and the transmission on a 1984 Ford Bronco 2. This plate is referred to as a flexplate, and it is used to connect the crankshaft of the engine to the torque converter of the transmission.
Auto Repair
How do you remove the brakes on a 1990 Isuzu Trooper? How much does it cost to change brake pads on a 2000 Toyota corolla?
Car Care
How To Tell Which TPMS Sensor Is Bad What is the height and weight restrictions for a child to sit in front seat car Ireland? When following another vehicle how much driving time should you maintain between your self and the are following?
Engine
No power to rear fuel pump tddi mondeo 02? 1998 Dodge Van 1500 lost power and would only drive around 5mph while running rough after pulling in the driveway it stalled now tries to start but stay running?
Electric Car
Will TBI system off a Chevy 305 work on 350 for 1987 Silverado 4x4? 2002 Chevy astro van The ac works good but no air comes out of the middle ducts dash Could this be a blockage or is there motor that vent only other vents seem to work fine.? 1990 gmc siera can you put a 1996 vortec 350 in it and if so is the cam just good as RV cam?
Autopilot
1995 Nissan altima speedometer gauge does not work? How can you jump start a 2006 Honda Shadow?
Car Photos
What should buyers watch for when looking a Chevrolet Silverado sale? What do the different symbols on dashboard of a diesel 1994 Peugeot 405 mean? Is it possible to have a lien on your vehicle even if you already the title?