- New oil filter (check your owner's manual for the correct size)
- New oil (check your owner's manual for the correct type and amount)
- Oil drain pan
- Funnel
- Wrench
- Rags
Instructions:
1. Park your car on a level surface and turn off the engine. Allow the engine to cool down for a few minutes.
2. Locate the oil drain plug. The oil drain plug is usually located on the bottom of the oil pan. It is typically a 17mm bolt.
3. Place the oil drain pan under the oil drain plug. Make sure the pan is large enough to catch all of the oil that will drain out.
4. Loosen the oil drain plug with the wrench. Be careful not to drop the bolt into the oil pan.
5. Allow the oil to drain completely. This may take a few minutes.
6. Replace the oil drain plug. Once all of the oil has drained out, screw the oil drain plug back in. Tighten the plug until it is snug.
7. Locate the oil filter. The oil filter is usually located near the top of the engine. It is a cylindrical-shaped object with a black cap.
8. Remove the oil filter. Use the wrench to loosen the oil filter. Be careful not to spill any oil.
9. Apply a thin coat of new oil to the gasket of the new oil filter. This will help to create a seal and prevent leaks.
10. Screw on the new oil filter. Hand-tighten the oil filter until it is snug. Do not overtighten the oil filter.
11. Add new oil to the engine. Use the funnel to add new oil to the engine. Add the amount of oil specified in your owner's manual.
12. Check the oil level. Use the dipstick to check the oil level. The oil level should be between the "full" and "add" marks on the dipstick.
13. Start the engine and let it run for a few minutes. This will circulate the new oil throughout the engine.
14. Check for leaks. Look under the car for any leaks. If you see any leaks, tighten the oil drain plug or oil filter until the leak stops.
