1. Park the car on a level surface and turn off the engine. Allow the engine to cool down completely.
2. Raise the front of the car using a jack and jack stands. Make sure the car is securely supported before you begin working.
3. Locate the power steering hose. It is a black rubber hose that runs between the power steering pump and the steering rack.
4. Disconnect the power steering hose from the pump and the steering rack. Use a wrench to loosen the hose clamps and then slide the hose off of the fittings.
5. Remove the old power steering hose from the car.
6. Install the new power steering hose. Slide the hose onto the fittings and then tighten the hose clamps.
7. Lower the car off of the jack stands.
8. Start the engine and check for leaks. If there are any leaks, tighten the hose clamps until the leaks stop.
Here is a diagram of the power steering hose location on a 1995 Buick Century:
[Image of a diagram of the power steering hose location on a 1995 Buick Century]
The diagram shows the power steering hose (labeled as "Hose") running between the power steering pump (labeled as "Pump") and the steering rack (labeled as "Rack").
