NOTE: You will need a T30 Torx bit and a Phillips screwdriver.
1. Open the hood of the vehicle and locate the camshaft position sensor. It is located on the passenger side of the engine, near the top of the cylinder head.
2. Remove the electrical connector from the camshaft position sensor by pressing on the release tab and pulling the connector straight up.
3. Use a T30 Torx bit to remove the two bolts that hold the camshaft position sensor in place.
4. Remove the old camshaft position sensor from the engine.
5. Inspect the old camshaft position sensor for any signs of damage or wear. If the sensor is damaged or worn, replace it.
6. Apply a small amount of grease to the new camshaft position sensor's O-ring.
7. Insert the new camshaft position sensor into the engine and secure it with the two bolts that you removed in step 3.
8. Reconnect the electrical connector to the camshaft position sensor.
9. Close the hood of the vehicle.
The camshaft position sensor is now replaced.
