Where is the camshaft position sensor located on a 1999 Dodge Intrepid 2.7 and what do you have to change it correctly?

The camshaft position sensor on a 1999 Dodge Intrepid 2.7 is located on the front of the engine, just below the intake manifold. It is held in place by two bolts. To change the sensor, you will need to:

1. Disconnect the negative terminal of the battery.

2. Remove the air intake hose.

3. Remove the two bolts that hold the sensor in place.

4. Remove the sensor from the engine.

5. Install the new sensor in the reverse order of removal.

6. Reconnect the negative terminal of the battery.

Here are some tips for changing the camshaft position sensor:

* Make sure that the engine is cold before you begin.

* Use a wrench to loosen the bolts that hold the sensor in place.

* Be careful not to drop the sensor when you remove it.

* Apply a small amount of sealant to the new sensor before you install it.

* Tighten the bolts that hold the sensor in place until they are snug.

* Reconnect the negative terminal of the battery and start the engine. Check for any leaks or unusual noises.