Locate the clutch slave cylinder. It is usually found near the bottom of the transmission, on the driver's side of the vehicle.
Clean the area around the slave cylinder to prevent any dirt or debris from entering the system.
Place a clear hose over the bleeder screw on the slave cylinder. The other end of the hose should be submerged in a container of brake fluid.
Loosen the bleeder screw slightly to allow air and fluid to escape.
Depress the clutch pedal slowly and hold it down.
While holding the clutch pedal down, tighten the bleeder screw.
Repeat steps 5 and 6 until no more air bubbles are visible in the brake fluid.
Top up the brake fluid reservoir to the correct level.
Test the clutch pedal to ensure it is working properly.
