Looking for a remote start wiring diagram my 93 bronco?

Here's a simplified, general wiring diagram for installing a remote start system in your 1993 Ford Bronco. Bear in mind that wiring colors and pin configurations may vary based on your specific vehicle and aftermarket remote start kit. For exact details, refer to your remote starter kit's installation instructions and the wiring diagram included with it.

Main Power Wiring ##

- Battery Positive (+12V Constant): Usually a red wire, connect to the vehicle's constant battery positive terminal.

- Battery Negative (Ground): Typically a black wire, connect to a solid metal mounting point or dedicated grounding point in the vehicle.

Ignition Wiring ##

- Ignition 1 (Accessory): Normally a yellow wire, connect to the vehicle's ignition 1 wire. This provides power to your accessories when the ignition is turned on.

- Ignition 2 (Run): Often a red wire, connect to the ignition 2 wire in your vehicle. This wire provides power to the starter and ignition system.

Starter Wiring ##

- Starter Signal or Crank: Usually a blue wire, connect to the vehicle's starter signal wire. This will engage the starter when you activate the remote start.

Door Lock/Unlock Wiring ##

- Lock/Unlock Wires (optional): Typically green and white wires, connect to the vehicle's door lock and unlock wires if you want remote locking and unlocking functionality with your remote starter.

Antenna/Status LED Wiring ##

- Antenna Wiring (optional): Connect the antenna wire to your remote start module. The LED wire can be used to indicate the status of the system.

General Steps ##

1. Disconnect the vehicle's battery before beginning the installation to prevent any electrical mishaps.

2. Locate the wiring harness behind your vehicle's ignition switch.

3. Tap into the appropriate wires listed above using T-taps or soldered connections (as recommended by the remote start kit's instructions).

4. Connect the wiring from your remote start module to the corresponding wires you've tapped into.

5. Secure all wiring connections with electrical tape or heat shrink to prevent short circuits.

6. Test the system to make sure it functions correctly.

Remember that this is just a basic guideline. The actual installation may require additional steps or modifications depending on the specific remote start system you're using. Always follow the detailed instructions that come with your remote starter kit for a proper installation. If you're not comfortable with electrical work or have any doubts, it's advisable to have the remote start system installed by a qualified professional.