- New oil filter (refer to your owner's manual for the correct size)
- Oil drain pan
- Funnel
- Wrench
- Rags
- Safety glasses
Instructions:
1. Park your truck on a level surface and engage the parking brake. Ensure the engine is cool and has been turned off for a while to avoid hot oil from scalding you.
2. Locate the oil filter housing. In the 2007 F250 diesel, it's usually on the top of the engine near the back. It's a cylindrical-shaped housing with an oil filter cap.
3. Place the oil drain pan underneath the oil filter housing. Make sure the pan is large enough to catch all the oil that will drain out.
4. Loosen the oil filter cap using a wrench. Turn the cap counterclockwise until it comes loose. Be careful not to drop the cap into the oil pan.
5. Allow the oil to drain from the filter housing into the drain pan. This may take a few minutes.
6. Remove the old oil filter from the housing. Once the oil has drained, you can remove the old filter by turning it counterclockwise.
7. Clean the oil filter housing. Use a rag to wipe away any old oil or debris from the housing.
8. Apply a thin coat of new oil to the gasket of the new oil filter. This will help to create a seal and prevent leaks.
9. Screw the new oil filter onto the housing. Hand-tighten the filter until it's snug. Do not over-tighten the filter, as this can cause damage.
10. Replace the oil filter cap. Screw the cap back onto the housing until it's snug.
11. Lower the vehicle off the jack stands.
12. Start the engine and let it run for a few minutes. This will allow the oil to circulate through the engine and filter.
13. Check for leaks. Inspect the oil filter housing and the oil drain plug for any leaks. If you see any leaks, tighten the filter or plug until the leak stops.
That's it! You have successfully changed the oil filter on your 2007 F250 diesel. Remember, it's essential to change your oil filter regularly to keep your engine running smoothly and efficiently. Please refer to your owner's manual for the recommended oil change intervals.
