* 10mm socket wrench
* Ratchet
* Extension
* Pliers
Instructions
1. Locate the camshaft sensor. The camshaft sensor is located on the front of the engine, near the top. It is a small, cylindrical sensor with a single wire connector.
2. Disconnect the electrical connector from the camshaft sensor.
3. Use a 10mm socket wrench to remove the two bolts that hold the camshaft sensor in place.
4. Remove the camshaft sensor from the engine.
5. Install the new camshaft sensor. Make sure to insert the new sensor into the engine so that the connector faces up.
6. Tighten the two bolts that hold the camshaft sensor in place.
7. Reconnect the electrical connector to the camshaft sensor.
8. Start the engine and check for any error codes.
