Tools and materials needed:
- Phillips-head screwdriver
- Flat-head screwdriver
- Torx wrench set
- Socket wrench set
- Replacement bumper (if necessary)
Step 1: Open the Hood:
- Open the hood of the Sprinter to access the bolts that hold the bumper in place.
Step 2: Remove the Wheel Well Liners:
- Use a Phillips-head screwdriver to remove the screws holding the wheel well liners in place.
- Gently pull the wheel well liners away from the bumper to expose the bumper mounting bolts.
Step 3: Remove the Bumper Cover Screws:
- Locate the screws along the top edge of the bumper cover near the headlights.
- Use a Torx wrench to remove these screws.
Step 4: Remove the Bumper Bolts:
- Use the socket wrench to loosen the bolts that secure the bumper to the vehicle frame.
- There are typically two bolts on each side of the bumper.
Step 5: Detach the Bumper from the Headlights:
- Gently pull the bumper away from the vehicle until you can see the clips that attach the bumper to the headlights.
- Press down on the clips with a flat-head screwdriver to release them.
Step 6: Disconnect the Wiring:
- Disconnect any wiring harnesses or sensors that may be attached to the bumper.
Step 7: Remove the Bumper:
- Once all the bolts are removed and wiring is disconnected, lift the bumper straight up and off the vehicle.
Step 8: Replace the Bumper Cover (Optional):
- If necessary, replace the bumper cover by lining it up with the mounting points and securing it with the screws and bolts you removed earlier.
Step 9: Reattach the Wheel Well Liners:
- Replace the wheel well liners by pushing them back into place and securing them with the screws you removed earlier.
Step 10: Test the Bumper:
- Gently push and pull on the bumper to ensure that it is securely mounted.
Closing the Hood: Close the hood of the Sprinter once you have finished removing or replacing the bumper.
Remember to take precautions when working on your vehicle and refer to the vehicle's service manual for specific instructions related to your Sprinter model.
