*A Phillips head screwdriver
*A flat head screwdriver
*A pair of pliers
Instructions:
1. Turn off the car and disconnect the battery. This will prevent any electrical damage from occurring while you are working on the stereo.
2. Use the Phillips head screwdriver to remove the two screws that hold the stereo in place. These screws are located on either side of the stereo.
3. Once the screws are removed, carefully pry the stereo out of the dash using the flat head screwdriver. Be careful not to damage the dashboard or the stereo.
4. Disconnect the wiring harness from the back of the stereo. There are three plugs that need to be disconnected: the power plug, the speaker plug, and the antenna plug.
5. Once the wiring harness is disconnected, remove the stereo from the car.
To install a new stereo, simply reverse the steps above. Be sure to connect the wiring harness correctly, as this could damage the new stereo.
