- Phillips head screwdriver
- Flat head screwdriver
- T20 Torx screwdriver
- 8mm socket wrench
- 10mm socket wrench
Here are the steps to change the headlight:
1. Open the hood of the car.
2. Locate the headlight assembly that you need to replace. It is located in the front of the car, on either side of the grill.
3. Remove the Phillips head screws that hold the headlight assembly in place. There are two screws located at the top of the assembly and one at the bottom.
4. Carefully pry around the headlight assembly with a flat head screwdriver. There are four clips holding the assembly in place.
5. Once the clips are released, lift the headlight assembly out of the car.
6. Disconnect the electrical connector from the back of the headlight assembly.
7. Remove the T20 Torx screws that hold the headlight in place. There are three screws on each side of the headlight.
8. Remove the 10mm socket wrench and remove the upper and lower bolts that hold the headlight in place.
9. Take the old headlight out of the headlight assembly.
10. Slide the new headlight into place and reconnect the electrical connector.
11. Secure the headlight in place with the screws you removed.
12. Replace the headlight assembly in the car and secure it with the screws, you removed.
13. Close the hood of the car.
The new headlight should now be installed.
