* Phillips Head Screwdriver
* Flathead Screwdriver
* Torx T-30 Screwdriver
* Socket Wrench Set
* Jack and Jack Stands
Instructions:
1. Park the car on level ground and apply the parking brake.
2. Jack up the front of the car and place it on jack stands.
3. Remove the nuts that secure the splash guards to the inner fenders.
4. Unsnap the front and side clips that hold the bumper on the car.
5. Lift up on the bumper and remove it from the car.
6. Disconnect the electrical connectors from the fog lights and turn signals.
7. Remove the two bolts that secure the bumper to the car.
8. Pull the bumper straight off the car.
9. Clean the mounting surface of the bumper.
10. Install a new bumper.
11. Hand-tighten the two bolts that secure the bumper to the car.
12. Connect the electrical connectors to the fog lights and turn signals.
13. Snap the front and side clips that hold the bumper on the car.
14. Install the nuts that secure the splash guards to the inner fenders.
15. Remove the jack stands and lower the car.
16. Start the engine and check the operation of the fog lights and turn signals.
