1. Open the hood.
- There is a push-pull tab on the front of the vehicle in the center of the hood.
- Pull the tab and open the hood.
- Prop the hood up with the support rod.
*The hood release is located inside the vehicle on the driver's side near the bottom.
2. Remove the old headlight.
- Locate the headlight assembly you wish to remove.
- There are two 10mm bolts that hold the headlight assembly in place. Loosen these bolts and remove them.
- Once the bolts are removed, you can remove the headlight assembly by pulling it forward.
- Disconnect the electrical connector from the back of the headlight assembly.
3. Install the new headlight.
- Position the new headlight assembly in place and reconnect the electrical connector.
- Replace the 10mm bolts and tighten them to secure the headlight assembly in place.
- Repeat steps 2 and 3 for the other headlight assembly if needed.
4. Close the hood.
- Lower the hood and release the support rod.
- Push down on the hood until it latches closed.
