1. If you have a rear view mirror attached between the two seat backs, remove it.
2. Pull up on the latch, located in the center of the seatback, and push the seatbacks towards the front of the car until the seatback is horizontal with the seat base.
Step 2: Remove the Front Bottom Seat Mounts
1. Locate the two round caps on the bottom of the seat between the seat squab and the seat back.
2. Remove the caps using your fingers or a small flat head screw driver.
3. There will be a nut, washer and bolt under each of the caps.
4. Remove the nut and washer using a wrench or socket set.
5. Repeat for the other seat mount.
Step 3: Push the Seat Cushions Out
1. Once the front seat mount bolts are removed, the seat cushion can be pushed out of the car.
2. There are two metal clips on the back of the seat cushion that go over the seat risers that were under the seat mount hardware previously removed.
3. Pry up on these clips with a screw driver and pull the seat cushions out of the car.
Step 4: Remove the Seat Belts
1. Unbolt the seat belts from the seat mounts.
2. Remove the seat belts from the car by pulling them out through the access holes in the rear parcel tray or rear seat back.
Step 5: Remove the Seat Backs
1. Once the front seat mount bolts are removed and the seat cushions are removed, the seat backs can be removed.
2. To remove the seat backs, grab them at the corners and wiggle them back and slightly up until the rear seat mounting studs come out of the floor pan and the seat back can be removed.
Step 6: Remove the Seat Back Release Levers
1. If you want to reuse the seat back release levers remove them while the seat backs are still removed.
2. To do this, pull up on the center button release while sliding the lever toward the rear of the car until it slides out of the retaining holes.
