- Phillips head screwdriver
- Flat head screwdriver
- 13mm wrench
_Instructions_
1. Loosen and remove the 2 Phillips screws located at the front of the seat rails.
2. Use a flathead screwdriver to pry the plastic covers off of the rear seat mounts.
3. Use a 13mm wrench to loosen and remove the 2 nuts holding the rear seat mounts in place.
4. Lift the front of the seat up and slide it out of the car.
5. Slide the rear of the seat out of the car.
6. To reinstall the seats, simply follow these instructions in reverse order.
_Tips:_
- Be careful not to drop the nuts when you are removing the rear seat mounts.
- You may need to use some force to pry the plastic covers off of the rear seat mounts.
- Be sure to tighten the nuts and screws until they are snug before you drive the car.
