Tools:
- Wrench
Steps:
1. Identify the clutch rod: The clutch rod is a long, thin metal piece connected to the clutch housing on the edger.
2. Locate the adjustment nut: The adjustment nut is usually located at the end of the clutch rod.
3. Loosen the adjustment nut: Use a wrench to loosen the adjustment nut until the clutch rod can be turned freely.
4. Turn the clutch rod: Turn the clutch rod clockwise until the belt is tight.
5. Tighten the adjustment nut: Once the belt is tight, tighten the adjustment nut to hold it in place.
6. Test the edger: Run the edger and check if the belt is properly tightened.
