1. Locate the seat switch: Typically, the seat switch is located under the seat of the riding mower. It is a small, black switch that is activated when someone sits on the seat.
2. Disconnect the wire: Disconnect the wire that is connected to the seat switch. This will disable the switch and prevent it from turning off the mower when someone leaves the seat.
3. Connect the wires: Connect the two wires that were disconnected from the seat switch together. This will complete the circuit and allow the mower to run even when no one is sitting on the seat.
4. Test the mower: Start the mower and verify that it runs properly without the seat switch activated.
It's important to note bypassing the seat switch may be a potential safety hazard, so use this solution only if absolutely necessary and exercise caution when operating the mower. It's always a good idea to ensure that the riding mower is in good working condition and that all safety features are functioning properly.
