1. Preparation:
* Consult a Repair Manual: A factory service manual or a reputable repair manual specific to your 1995 Chrysler New Yorker is crucial. It will provide detailed diagrams, torque specifications, and potentially even specific instructions for your wiper linkage.
* Gather Tools: You'll need a variety of tools, likely including:
* Socket set (metric)
* Wrenches (metric)
* Screwdrivers (Phillips and possibly flathead)
* Pliers (needle-nose might be helpful)
* Penetrating oil (like PB Blaster)
* Replacement bushing(s) – Crucial: Obtain the correct replacement bushing(s) from a reputable parts supplier. Provide your VIN for accurate parts identification.
* A small pry bar or similar tool might be useful for separating parts.
* Rags or shop towels
* Disconnect the Battery: This is a safety precaution to prevent accidental short circuits.
2. Accessing the Wiper Linkage:
* Remove the Wiper Arms: This usually involves using a wiper arm puller tool. If you don't have one, you *can* try carefully using pliers, but be extremely cautious to avoid scratching the windshield. Mark the arms' position before removal for easier reinstallation.
* Remove the Wiper Cowl: This plastic cover protects the linkage. It's usually held on by clips or screws. Carefully remove it to expose the linkage.
* Locate the Bushing(s): The bushing(s) are likely located where the wiper linkage pivots or articulates. Your repair manual will show their exact location. They might be encased in metal or plastic.
3. Replacing the Bushing(s):
* Remove the Old Bushing(s): This is often the most challenging part. Depending on the bushing type, you may need to:
* Press it out: Use a suitable socket or punch and a hammer to carefully press the bushing out of its housing. Be gentle to avoid damaging the linkage.
* Pry it out: If accessible, use a small pry bar to carefully leverage the bushing out.
* Drill it out: In some cases, the bushing might be corroded and require drilling. Use caution to avoid damaging surrounding parts.
* Install the New Bushing(s): Carefully press the new bushings into place. A socket of the correct size can help guide and evenly distribute the force. You might need a lubricant (like silicone grease) to help with installation.
4. Reassembly:
* Reinstall the Wiper Cowl: Secure it with the clips or screws.
* Reinstall the Wiper Arms: Make sure they are properly aligned with the linkage and tighten securely. Use the markings you made earlier.
* Reconnect the Battery:
* Test the Wipers: Turn on the wipers to ensure they operate smoothly and correctly.
Important Considerations:
* Corrosion: On a 1995 vehicle, corrosion is likely a significant factor. Penetrating oil will be your friend in loosening seized parts. Be patient and allow ample time for it to work.
* Damage: If you're unsure about any step, it's best to seek professional help. Damaging the linkage can be costly to repair.
* Safety: Always wear safety glasses to protect your eyes from flying debris.
Remember, this is a general guide. Refer to your repair manual for specific instructions and diagrams tailored to your 1995 Chrysler New Yorker. If you lack experience with car repair, seeking professional help is recommended to avoid potential damage.
