1. Preparation:
* Disconnect the battery: This is crucial to prevent short circuits and electrical shocks. Disconnect the negative (-) terminal first.
* Gather tools: You'll likely need a panel removal tool (plastic pry tool is best to avoid scratching), a Phillips head screwdriver, possibly a flathead screwdriver, and possibly a socket wrench (depending on how the speaker is mounted). Have a flashlight handy.
* Acquire replacement speakers: Make sure you buy speakers that fit the existing mounting holes and have the correct impedance (ohm rating). Match the size to your existing speakers as closely as possible. Often, 6x9" speakers are used in the rear of the Intrigue, but this is not guaranteed.
2. Accessing the Speakers:
* Locate the speakers: These are typically located in the rear side panels of the trunk or behind the rear seats (depending on the Intrigue model). You will need to access the speaker through a panel or trim piece in one of these locations. The location will usually be relatively obvious once the interior panel is removed.
* Remove the rear side panels/trim: This is where the plastic pry tool comes in. Gently insert the tool into the gaps between the panel and the car body. Work your way around the perimeter of the panel, carefully releasing the clips that hold it in place. Be gentle to avoid breaking the clips. There may be screws involved as well – check carefully before prying. You may have to remove some other interior trim pieces to fully access the speaker.
3. Removing the Old Speakers:
* Disconnect the speaker wires: Once you've accessed the speaker, carefully disconnect the wiring harness connected to the speaker. Take a picture or make a note of how the wires are connected before disconnecting them to aid in reassembly.
* Remove the speaker: The speaker is typically held in place by screws or clips. Unscrew the screws or carefully pry the speaker loose from its mounting bracket.
4. Installing the New Speakers:
* Connect the new speaker wires: Connect the wires from your new speaker to the car's wiring harness, matching the color codes (or your notes from step 3).
* Mount the new speaker: Carefully install the new speaker into the mounting location, securing it with screws or clips (whatever was used for the old speaker).
* Reinstall the rear side panels/trim: Carefully put the panels back in place, lining up the clips and screws.
5. Testing:
* Reconnect the battery: Reconnect the positive (+) terminal first, then the negative (-).
* Test the speakers: Play some music through your car's sound system and make sure the new speakers are working correctly.
Important Notes:
* If you're not comfortable working on your car's electrical system or interior, take it to a professional installer. Improper installation can damage your car's electrical system or your speakers.
* Be gentle when removing and installing panels and speakers. You can easily damage the clips or the car's interior if you're too forceful.
* Take pictures along the way to assist you in reassembly if you run into any problems.
This is a general guide, and the specifics might differ for your particular 2000 Oldsmobile Intrigue. Searching for "2000 Oldsmobile Intrigue rear speaker replacement" along with videos on YouTube might provide more visual guidance specific to your model. Remember safety first!
