How do you refill the rear window washer fluid on a 2000 dodge durango?

The 2000 Dodge Durango's rear washer fluid reservoir is typically located in the same compartment as the front washer fluid reservoir, under the hood. However, there isn't a separate filler cap for the rear washer. The system is usually a single reservoir that supplies both the front and rear washers.

To refill the fluid:

1. Open the hood: Locate the hood release lever inside the vehicle (usually near the steering wheel or under the dashboard) and pull it to release the hood latch. Then, lift the hood.

2. Locate the washer fluid reservoir: It's a usually a translucent plastic bottle, often found near the front of the engine compartment. It will likely be labeled "Washer Fluid" or have a similar marking. The cap will typically be a screw-top style.

3. Remove the cap: Unscrew the cap and carefully lift it off.

4. Add washer fluid: Use a funnel to pour the correct type of washer fluid into the reservoir. Do not overfill – the reservoir has a maximum fill line; avoid exceeding it.

5. Replace the cap: Screw the cap back on tightly.

6. Test the system: Turn on your rear washer to make sure the fluid is flowing to the rear wiper.

If you can't locate a single reservoir, consult your owner's manual. It will have diagrams and instructions specific to your vehicle. If you still have trouble finding it, a quick search online for "2000 Dodge Durango washer fluid reservoir location" may yield helpful images or videos.