To refill the rear washer fluid:
1. Locate the washer fluid reservoir: This is usually a translucent plastic bottle located in the engine compartment. It's often near the firewall (the wall separating the engine compartment from the passenger compartment) and will have a cap marked with a washer fluid symbol (often a little picture of a windshield with fluid squirting out).
2. Open the hood: Use the hood release lever (usually located near the steering column or under the dashboard) to open the hood. Consult your owner's manual if you have trouble finding it.
3. Locate the cap: Once you've located the reservoir, carefully remove the cap.
4. Add washer fluid: Add washer fluid to the reservoir. Don't overfill; there's usually a maximum fill line indicated on the bottle. Use a washer fluid that's appropriate for the climate (winter-grade fluid with antifreeze if it's cold).
5. Replace the cap: Securely replace the cap on the reservoir.
6. Test the rear wiper: Turn on your rear wiper and washer to ensure it's working correctly.
If, after doing this, your rear washer still doesn't work:
* Check for clogs: There might be a clog in the rear washer line. This requires more detailed inspection.
* Check the pump: The washer pump might be faulty. This will likely require a mechanic's attention.
* Check the fuse: A blown fuse could also be the issue. Consult your owner's manual to locate the fuse box and diagram to find the correct fuse.
Remember to always consult your owner's manual for the most accurate and vehicle-specific instructions. The location of the reservoir and other components might vary slightly depending on the trim level of your 2003 Ford Laser.
