Tools You'll Need:
* Socket wrench set (metric)
* Phillips head screwdriver
* Flathead screwdriver (possibly)
* New washer pump
* Container to catch spilled washer fluid
* Rags or shop towels
* Safety glasses
Steps:
1. Disconnect the Battery: This is crucial for safety. Disconnect the negative (-) terminal first.
2. Locate the Washer Pump: The washer pump is typically located in the engine compartment, often near the washer fluid reservoir. It's usually a small, cylindrical pump. The reservoir itself might be behind the bumper, under the hood, or even within the wheel well. Your repair manual will pinpoint its exact location.
3. Drain the Washer Fluid Reservoir: Open the cap to the washer fluid reservoir and carefully drain as much fluid as possible into a container. This prevents spills.
4. Access the Pump: You'll likely need to remove some components to access the pump. This might involve removing the wheel well liner or other parts to gain visibility. Again, your repair manual is crucial here. Sometimes there's a small access panel.
5. Disconnect the Electrical Connector: Carefully unplug the electrical connector from the washer pump. Take note of how it connects to easily re-attach the new pump.
6. Disconnect the Washer Lines: There will be two lines connected to the pump: one for the supply of fluid and one for the return. Use pliers or a wrench (depending on the type of connection) to disconnect these lines. Have rags ready to catch any spilled fluid. Some systems use quick-disconnect fittings, while others use hose clamps.
7. Remove the Pump: Once the electrical connector and washer lines are disconnected, you can remove the pump. This might involve removing a few bolts or clips holding it in place.
8. Install the New Pump: Install the new washer pump, ensuring it's properly seated. Re-attach any bolts or clips.
9. Reconnect the Washer Lines: Reconnect the washer lines to the new pump, making sure they are secure.
10. Reconnect the Electrical Connector: Carefully connect the electrical connector to the new pump.
11. Refill the Washer Fluid Reservoir: Refill the washer fluid reservoir with the correct type of washer fluid.
12. Reconnect the Battery: Reconnect the positive (+) terminal and then the negative (-) terminal to the battery.
13. Test the System: Turn on your windshield washer system to test the new pump. If it doesn't work, double-check all connections and ensure there are no leaks.
Important Considerations:
* Repair Manual: A repair manual specific to your year and model of Plymouth Breeze is invaluable. It will provide diagrams and detailed instructions.
* Safety: Always wear safety glasses and work in a well-ventilated area.
* Difficulty: The difficulty of this repair can vary depending on the specific vehicle. Some Breeze models may be easier to access than others.
If you're not comfortable performing this repair yourself, it's always best to take your vehicle to a qualified mechanic. Improper installation could lead to further problems.
