- Wrench set
- Socket set
- Brake fluid
- Brake bleeder wrench
2. Prepare the vehicle.
- Park the vehicle on a level surface.
- Turn off the engine and allow it to cool down.
- Engage the parking brake.
- Chock the wheels.
- Locate the brake fluid reservoir. It is typically located in the engine bay, near the master cylinder.
- Make sure the reservoir is full of brake fluid.
3. Bleed the brake line.
- Start by bleeding the brake line at the wheel that is furthest from the master cylinder.
- Attach the brake bleeder wrench to the bleeder screw on the wheel caliper.
- Open the bleeder screw slightly.
- Have an assistant press the brake pedal slowly and firmly.
- When the brake fluid starts to flow out of the bleeder screw, close the screw.
- Repeat steps 4 and 5 until the old brake fluid has been completely replaced with new brake fluid.
4. Repeat steps 3 and 4 for each of the remaining wheels, working from the wheel furthest from the master cylinder to the wheel closest to the master cylinder.
5. Check the brake fluid level in the master cylinder reservoir.
- Make sure the reservoir is full of brake fluid.
- Top off the reservoir if necessary.
6. Test the brakes.
- Apply the brakes several times to make sure they are working properly.
7. Take the vehicle for a test drive.
- Make sure the brakes work properly before driving the vehicle.
