- Soldering iron
- Solder
- Flux
- Replacement display panel
- Small Phillips head screwdriver
- Flathead screwdriver
Instructions:
1. Remove the radio from the dashboard by removing the screws that hold it in place.
2. Once the radio is removed, you will need to remove the faceplate by gently prying it off with a flathead screwdriver.
3. Locate the display panel on the back of the faceplate. It is usually held in place by a few screws or clips.
4. Remove the screws or clips that hold the display panel in place and carefully remove the panel.
5. Compare the new display panel with the old one to make sure they are the same size and shape.
6. If the new panel is correct, install it into the faceplate by lining it up with the mounting holes and securing it with the screws or clips you removed earlier.
7. Replace the faceplate on the radio and secure it with the screws you removed earlier.
8. Reinstall the radio in the dashboard.
Note: If the display panel is not working, you may need to replace the radio.
