- Jack & jack stands
- Wrench set
- Socket set
- Flat-head screwdriver
- Brake fluid
- Brake cleaner
- New brake pads
Instructions:
1. Park the truck and turn off the engine. Engage the parking brake.
2. Loosen the lug nuts on the front wheels. Do not remove the nuts completely.
3. Raise the truck with the jack and place it on jack stands. Make sure the truck is securely supported before you begin working.
4. Remove the lug nuts and take off the front wheels.
5. Locate the brake caliper. It is the metal housing that holds the brake pads in place.
6. Remove the bolts that hold the caliper in place and remove the caliper. Be careful not to damage the brake fluid line.
7. Use a flat-head screwdriver to pry the brake pads out of the caliper bracket.
8. Clean the caliper bracket with brake cleaner. Make sure to remove all dirt and debris.
9. Apply a thin layer of brake grease to the caliper bracket. This will help prevent the brake pads from sticking.
10. Install the new brake pads into the caliper bracket. Make sure the pads are seated properly.
11. Reinstall the caliper and the bolts that hold it in place. Tighten the bolts securely.
12. Reinstall the wheels and lug nuts. Tighten the lug nuts until they are snug.
13. Lower the truck off the jack stands.
14. Check the brake fluid level in the master cylinder. If it is low, add brake fluid until it reaches the "Full" mark.
15. Test the brakes by pumping the brake pedal a few times. The pedal should feel firm and not spongy.
Tips:
- If the brake pads are excessively worn, you may need to replace the rotors as well.
- Be careful not to get brake fluid on your skin or in your eyes. Brake fluid is corrosive and can cause irritation.
- If you have any questions or concerns about changing your brake pads, please consult with a qualified mechanic.
