A new brake light bulb
A Phillips head screwdriver
A flathead screwdriver
Instructions:
1. Park your car in a safe location and turn off the engine.
2. Locate the brake light bulb housing on the rear of your car. It is typically located on the side of the taillight assembly.
3. Use the Phillips head screwdriver to remove the screws that hold the brake light bulb housing in place.
4. Once the screws are removed, use the flathead screwdriver to pry open the brake light bulb housing.
5. Remove the old brake light bulb from the housing by turning it counterclockwise.
6. Install the new brake light bulb by turning it clockwise until it is snug.
7. Replace the brake light bulb housing and secure it with the screws you removed earlier.
8. Turn on the headlights to test the new brake light bulb.
Note: Always make sure the new brake light bulb is the correct size and type for your vehicle. If you are unsure of what type of bulb you need, you can check your vehicle's owner's manual or consult with an auto parts store employee.
