* Phillips-head screwdriver
* Flat-head screwdriver
* Socket wrench set
* Extension
* 10 mm socket
* Ratchet
Instructions
1. Park your van in a safe location and turn off the engine.
2. Open the hood of your van.
3. Locate the windshield wiper motor. It is located on the passenger side of the engine compartment, near the firewall.
4. Disconnect the electrical connector from the windshield wiper motor.
5. Remove the three bolts that hold the windshield wiper motor in place.
6. Remove the windshield wiper motor from the vehicle.
7. Install the new windshield wiper motor in reverse order of removal.
8. Test the windshield wipers to make sure they are working properly.
Tips
* Be careful not to drop the bolts when you are removing them.
* If the bolts are rusted, you may need to use a penetrating oil to loosen them.
* Make sure that the new windshield wiper motor is properly seated before you tighten the bolts.
* Test the windshield wipers before you close the hood of your van.
