Interior Passenger Door Handle:
1. Remove the door panel.
- Unscrew the screws holding the door panel in place.
- Disconnect any cables or rods attached to the door handle.
- Carefully pry off the door panel.
2. Locate the door handle assembly:
- The door handle assembly is usually attached to the door with bolts or screws.
3. Disconnect the door handle cable.
- Look for the cable connected to the door handle assembly.
- Detach the cable from the handle.
4. Remove the door handle assembly.
- Unscrew the bolts or screws holding the door handle assembly in place.
- Remove the old door handle assembly from the door.
5. Install the new door handle assembly.
- Place the new door handle assembly in the door.
- Secure it with the bolts or screws you removed earlier.
- Reconnect the door handle cable.
6. Reinstall the door panel.
- Carefully align the door panel with the door and snap it into place.
- Reinstall the screws you removed earlier.
- Test the new door handle to ensure it works correctly.
Outside Driver's Door Handle:
1. Remove the exterior door handle cover or bezel:
- Locate the small screws or tabs that hold the exterior door handle cover in place.
- Use a screwdriver to remove these and carefully pry off the cover.
2. Locate the door handle assembly.
- Once the cover is removed, you should see the door handle assembly with its mounting screws.
3. Detach the door handle link:
- Find the metal rod connecting the door handle to the door latch mechanism. Disconnect this link by unhooking the small clip or removing a retaining screw.
4. Remove the mounting screws.
- Unscrew the mounting screws that hold the door handle assembly in place.
5. Remove the door handle assembly.
- Pull the door handle assembly out from the outside of the door.
6. Install the new door handle assembly:
- Insert the new door handle assembly into the door from the outside.
- Secure it with the mounting screws.
- Reattach the door handle link.
7. Reinstall the exterior door handle cover or bezel:
- Align the cover with the door and snap it into place, making sure it fits snugly.
8. Test the new door handle.
- Open and close the door several times to ensure the handle operates smoothly and the door opens and closes properly.
Remember to disconnect the battery before working on the electrical components of the door. Also, be careful not to lose any small parts or clips during disassembly. If you are not comfortable with any of the steps, consult a professional for assistance.
