1. Remove the cylinder head.
2. Remove the valves and springs.
3. Take the valve head and stem to a machine shop to have them straightened.
4. Reassemble the valves and springs.
5. Reinstall the cylinder head.
Here are some additional details on each step:
1. To remove the cylinder head, you will need to:
- Disconnect the hoses and wires connected to the cylinder head.
- Remove the bolts holding the cylinder head in place.
- Use a pry bar to carefully lift the cylinder head off of the engine block.
2. To remove the valves and springs, you will need to:
- Use a valve spring compressor to compress the valve springs.
- Remove the valve keepers and collets.
- Remove the valve springs and valves.
3. To have the valve head and stem straightened, you will need to take them to a machine shop that has the necessary equipment.
4. To reassemble the valves and springs, you will need to:
- Install the valve springs on the valves.
- Install the valve keepers and collets.
- Use a valve spring compressor to compress the valve springs.
5. To reinstall the cylinder head, you will need to:
- Place the cylinder head gasket on the engine block.
- Carefully lower the cylinder head onto the engine block.
- Install the bolts holding the cylinder head in place.
- Connect the hoses and wires that you disconnected earlier.
