- Car jack
- Jack stands
- Wheel chock
- Lug wrench
- Socket wrench set
- pry Bar
- New wheel bearing
Instructions:
1. Park the vehicle on a level surface and apply the parking brake.
2. Jack up the rear of the vehicle and support it on jack stands.
3. Remove the lug nuts and take off the wheel.
4. Use a pry bar to remove the brake drum.
5. Remove the old wheel bearing from the hub.
6. Press the new wheel bearing in to the hub.
7. Replace the brake drum and wheel.
8. Lower the vehicle and remove the jack stands.
Make sure to correctly and safely dispose of the old bearing and parts if applicable.
