1.Gather Tools and Parts
- Replacement alternator belt
- 13 mm socket
- ratchet
- breaker bar
-flathead screwdriver
2. Disconnect the Battery
Disconnect the negative battery terminal to prevent any electrical accidents.
3. Locate the Alternator Bolt
On the backside of the alternator, locate the 13 mm bolt that secures the alternator to the engine.
4. Remove the Alternator Bolt
Use the 13 mm socket and ratchet to loosen and remove the alternator bolt. Do not completely remove the bolt yet.
5. Pry the Alternator
Using the flathead screwdriver, pry the alternator away from the engine block to create enough space to slip the new belt. Be careful not to damage the alternator or any surrounding components.
6. Remove the Old Belt
Once you have created enough space, remove the old alternator belt from the pulleys.
7. Route the New Belt
Position the new alternator belt around the pulleys, starting with the crankshaft pulley, then the idler pulley, and finally the alternator pulley. Make sure the belt is properly seated in the grooves of the pulleys.
8. Tighten the Alternator Belt
To tension the belt, use the 13 mm socket and ratchet to tighten the alternator bolt. Tighten the bolt until the belt has the proper tension. Refer to your vehicle's owner's manual for the recommended belt tension specification.
9. Reconnect the Battery
Reconnect the negative battery terminal to restore power to the vehicle.
10. Test the Belt
Start the engine and let it run for a few minutes. Observe the belt to ensure that it is properly aligned and not slipping. If it is not, adjust the tension as necessary.
Remember, if you are not confident in performing this task or do not have the necessary tools, it is best to have the alternator belt change done by a qualified mechanic.
