Disclaimer: This guide is provided for informational purposes only and does not constitute a complete tutorial. Always refer to your vehicle's owner's manual for specific instructions and safety information before attempting any repairs or maintenance. If you are uncomfortable with any part of the process, it is recommended that you consult with a professional mechanic.
Materials and Tools Needed:
- New engine oil (refer to your vehicle's owner's manual for the correct type and amount)
- New oil filter (refer to your vehicle's owner's manual for the correct size)
- Oil drain pan
- Funnel
- Wrench
- Rags
- Gloves
- Safety glasses
Instructions:
1. Prepare your vehicle.
- Park your car on a level surface, apply the parking brake, and turn off the engine.
- Allow the engine to cool down for a few minutes to avoid burning yourself.
- Engage the parking lock on the transmission.
- If necessary, raise the vehicle using a lift or ramps to provide better access underneath the car.
2. Locate the oil drain plug.
- The oil drain plug is typically located on the bottom of the oil pan.
- On some models, it may be necessary to remove an underbody panel or skid plate to access the drain plug.
3. Place the oil drain pan.
- Position the oil drain pan directly underneath the oil drain plug to catch the old oil.
- Make sure the pan is large enough to hold all the oil that will drain out.
4. Loosen the oil drain plug.
- Use the wrench to loosen the oil drain plug.
- Be careful as hot oil may splash out.
5. Allow the old oil to drain.
- Allow all of the old oil to drain out completely.
- This may take a few minutes.
6. Replace the oil drain plug.
- Once all the oil has drained out, replace the oil drain plug.
- Tighten the plug securely using the wrench.
7. Locate the oil filter.
- The oil filter is typically located near the top of the engine.
- On some models, it may be necessary to remove an engine cover or air filter housing to access the oil filter.
8. Remove the old oil filter.
- Use the wrench to loosen the oil filter.
- Be careful as some oil may spill out.
- Remove the oil filter by turning it counterclockwise.
- Discard the old oil filter and its gasket properly.
9. Apply a thin layer of new oil to the gasket of the new oil filter.
- This will help create a seal and prevent leaks.
10. Screw on the new oil filter.
- Screw on the new oil filter by turning it clockwise until it is hand-tight.
- Do not over-tighten the oil filter.
11. Add new engine oil.
- Use the funnel to add the specified amount of new engine oil to the engine.
- Refer to your vehicle's owner's manual for the correct amount.
12. Check the oil level.
- Use the dipstick to check the oil level.
- The oil level should be between the "full" and "add" marks on the dipstick.
13. Start the engine and let it run for a few minutes.
- This will circulate the new oil throughout the engine.
14. Check for leaks.
- Inspect the areas around the oil drain plug and oil filter for any leaks.
- If you see any leaks, tighten the plug or filter as needed.
15. Lower the vehicle.
- If you raised the vehicle using a lift or ramps, lower it back down to the ground.
16. Dispose of the old oil and filter properly.
- Take the old oil and filter to a recycling center or auto parts store for proper disposal.
By following these instructions, you can safely change the oil in your 2015 BMW 750i. Remember to always refer to your vehicle's owner's manual for specific instructions and safety information. If you are in any doubt about your ability to perform this task, it is recommended that you consult with a professional mechanic.
