1. Tools Needed:
- Wrenches
- Socket set
- Screwdriver
2. Loosen the Axle Nut:
- Locate the axle nut located on the right side of the rear wheel.
- Use a wrench to loosen the axle nut, but don't remove it completely.
3. Adjust Chain Tension:
- Loosen the rear axle adjusters nuts on both sides of the swing arm.
- Turn the adjusters to move the rear wheel back or forward to adjust the chain tension.
- The proper chain tension should allow for 1 to 1 1/2 inches of play in the middle of the bottom run.
4. Tighten Axle Adjusters Nuts:
- Once the desired chain tension is achieved, tighten the rear axle adjusters nuts on both sides to secure the position of the rear wheel.
5. Tighten Axle Nut:
- Finally, tighten the axle nut on the right side of the rear wheel to its original tightness.
6. Verify Alignment:
- Check the alignment of the rear wheel by ensuring it is centered with the frame and the belt drive.
- Make adjustments if needed by turning the adjusters on both sides of the swingarm.
7. Recheck Chain Tension:
- Double-check the chain tension to make sure it hasn't changed during the alignment process.
- Adjust as needed.
8. Tighten Adjuster Lock Nuts:
- Tighten the adjuster lock nuts on both sides of the swingarm to secure the chain tension adjustment.
9. Test Ride:
- Take a short test ride to ensure the chain tension and alignment are correct and there are no unusual noises.
10. Final Tightening:
- After the test ride, let the bike cool down, then re-tighten the axle nut and the adjuster lock nuts to their final tightness.
Remember, proper chain tension is crucial for the performance and longevity of your motorcycle's driveline. If you're unsure about any of these steps or have concerns about the safety or integrity of your bike, it's best to consult with a qualified mechanic or refer to your bike's service manual.
