Auto >> AutoSPT >  >> Auto Repair

How do you reset the brake light and ABS on dash of a 1997 dodge Dakota?

1. Turn the ignition switch to the "Off" position.

2. Locate the diagnostic connector under the dash, on the driver's side. It is usually a black plastic connector with a cover.

3. Remove the cover from the diagnostic connector.

4. Insert a jumper wire into the "A" and "B" terminals of the diagnostic connector.

5. Turn the ignition switch to the "On" position, but do not start the engine.

6. The ABS and brake lights on the dash should illuminate for a few seconds, then turn off.

7. Remove the jumper wire from the diagnostic connector.

8. Turn the ignition switch to the "Off" position.

9. Start the engine and verify that the ABS and brake lights are off.

Auto Repair
What is the best auto repair shop in Austin? Car Shakes At Idle But Smooths Out While Driving – Causes & Fixes
Car Care
Car Ramp Safety When buying a used Porsche from dealer how to know the bought is approved? AN OUNCE OF PREVENTION = A POUND OF CURE PT.2
Engine
How can you improve the drum brakes on a 1966 Toronado? How do you replace the front strut motor mount on a 1993 Chevy Corsica 3.1 engine?
Electric Car
How can detect a bad car thermostat? What was the first car invented? How many miles on your Chevrolet silverado?
Autopilot
Are Driverless Car Accidents Putting Their Whole Future at Risk? How do you set the timing on a 1996 f150 six cyl?
Car Photos
Do you have a fuse panel diagram for 1998 new beetle? Where is the pcv valve on a 1999 Honda Civic dx located? What is the stock wheel size of c4 Corvette?