* 17mm wrench
* 19mm wrench
* 12mm wrench
* Phillips head screwdriver
* Flat head screwdriver
* Hammer
1. Park the TRX 300 on a flat surface and engage the parking brake.
2. Loosen the lug nuts on the rear wheels with the 19mm wrench.
3. Raise the TRX 300 off the ground using a jack and jack stands.
4. Remove the lug nuts and take off the rear wheels.
5. Use the 17mm wrench to remove the axle nuts from both sides of the axle.
6. Use the flat head screwdriver to pry off the dust seals on both sides of the axle.
7. Use the 12mm wrench to remove the four bolts holding the brake caliper in place.
8. Remove the brake caliper and hang it out of the way with a piece of wire.
9. Use the hammer to knock the axle out of the differential.
10. Inspect the axle for damage and replace if necessary.
11. Reassemble the rear axle in the reverse order of disassembly.
Be sure to tighten all bolts and nuts to the proper specifications.
