1. Locate the brake pedal. It is on the right side of the motorcycle, near the rear wheel.
2. Look for the brake adjuster. It is a small screw located on the bottom of the brake pedal.
3. Use a screwdriver to turn the adjuster screw. Turning the screw clockwise will tighten the brake, while turning it counterclockwise will loosen it.
4. Test the brake to make sure it is properly adjusted. The brake should be tight enough to stop the motorcycle without being too difficult to press.
5. If necessary, repeat steps 3 and 4 until the brake is properly adjusted.
Here are some additional tips for adjusting the rear brake on a 2005 Harley Dyna Low Rider:
* Make sure the motorcycle is in neutral and the engine is off.
* Use a flashlight if you are working in a dark area.
* Be careful not to over-tighten the brake adjuster screw. This could cause the brake to lock up.
* If you are unsure how to adjust the rear brake, consult your motorcycle's owner's manual or a qualified mechanic.
