1. Gather your materials. You will need:
* A 10mm socket wrench
* A 14mm socket wrench
* A funnel
* A quart of SAE 10W-40 motor oil
2. Locate the clutch oil fill plug. It is located on the right side of the engine, just below the clutch cover.
3. Remove the fill plug. Use the 10mm socket wrench to loosen the fill plug, and then remove it by hand.
4. Check the oil level. The oil should be at the bottom of the fill hole. If it is not, add oil until it reaches the bottom of the hole.
5. Replace the fill plug. Use the 10mm socket wrench to tighten the fill plug.
6. Start the engine and let it run for a few minutes. This will circulate the oil and ensure that it is properly distributed.
7. Check the oil level again. The oil level should still be at the bottom of the fill hole. If it is not, add oil until it reaches the bottom of the hole.
