Auto >> AutoSPT >  >> Auto Repair

How do you remove a Dyna wide glide rear fender?

To remove a Dyna wide glide's rear fender, you will need the following tools:

* Socket wrench

* Phillips head screwdriver

* Flathead screwdriver

1. Remove the seat. To do this, locate the two screws that hold the seat in place and remove them with the Phillips head screwdriver.

2. Disconnect the taillight. There are two wires that connect the taillight to the bike. Disconnect these wires by pulling on the connectors with your hands.

3. Remove the fender struts. There are two fender struts that hold the fender in place. Remove these struts by first removing the bolts that hold them to the frame with the socket wrench. Then, remove the nuts that hold them to the fender with the flathead screwdriver.

4. Remove the fender. Once the fender struts have been removed, you can remove the fender by lifting it up and off of the bike.

Note: Be careful when removing the rear fender as there is a fuel line located underneath it. Make sure to disconnect the fuel line before removing the fender.