Auto >> AutoSPT >  >> Auto Repair

How do you remove a k reg vauxhall cavaliar factory fitted alam?

To remove the factory-fitted alarm from a K Reg Vauxhall Cavalier, you will need the following tools and materials:

- A flat-head screwdriver

- A Phillips-head screwdriver

- A pair of pliers

- Electrical tape

Step 1: Disconnect the battery

1. Open the bonnet of your Cavalier and locate the battery.

2. Use the flat-head screwdriver to loosen the negative battery terminal (marked with a "-").

3. Remove the negative battery cable from the terminal and set it aside.

Step 2: Remove the alarm siren

1. Locate the alarm siren, which is usually mounted in the engine bay near the battery.

2. Use the Phillips-head screwdriver to remove the screws that hold the siren in place.

3. Disconnect the electrical connectors from the siren.

Step 3: Remove the alarm control unit

1. Open the driver's side door and remove the lower dash panel by prying it off with the flat-head screwdriver.

2. Locate the alarm control unit, which is usually mounted behind the dash panel.

3. Use the Phillips-head screwdriver to remove the screws that hold the control unit in place.

4. Disconnect the electrical connectors from the control unit.

Step 4: Remove the wiring

1. Use the pliers to cut the alarm wires from the vehicle's wiring harness.

2. Cap off the ends of the wires with electrical tape to prevent them from shorting out.

Step 5: Reconnect the battery

1. Reattach the negative battery cable to the negative battery terminal.

2. Tighten the terminal screw with the flat-head screwdriver.

The factory-fitted alarm should now be removed from your K Reg Vauxhall Cavalier.