* Automatic transmission
* Torque converter
* Transmission mount
* Driveshaft
* Differential
* Transmission control module (TCM)
* Wiring harness
* Fluid lines
Step 2: Remove the manual transmission
1. Disconnect the negative battery terminal.
2. Raise the vehicle and support it on jack stands.
3. Remove the transmission crossmember.
4. Disconnect the clutch cable from the transmission.
5. Remove the starter motor.
6. Remove the bell housing bolts and separate the transmission from the engine.
7. Remove the transmission mount.
Step 3: Install the automatic transmission
1. Install the transmission mount.
2. Align the transmission with the engine and install the bell housing bolts.
3. Connect the clutch cable to the transmission.
4. Install the starter motor.
5. Install the transmission crossmember.
6. Lower the vehicle.
7. Connect the negative battery terminal.
Step 4: Install the torque converter
1. Install the torque converter into the transmission.
2. Install the transmission fluid pan and fill it with fluid.
Step 5: Install the driveshaft
1. Install the driveshaft and connect it to the differential.
2. Install the differential fluid cover and fill it with fluid.
Step 6: Install the transmission control module (TCM)
1. Install the TCM in the vehicle and connect it to the wiring harness.
Step 7: Test the transmission
1. Start the engine and allow it to warm up.
2. Shift the transmission into each gear and ensure that it engages properly.
3. Test drive the vehicle to ensure that the transmission shifts smoothly and properly.
Step 8: Reset the transmission adaptive values
1. Connect a scan tool to the vehicle's diagnostic port.
2. Access the transmission control module (TCM) menu.
3. Reset the transmission adaptive values.
This is a general overview of the process, but it is important to note that the actual steps involved may vary depending on the specific vehicle model and transmission type. It is also important to ensure that you have the necessary knowledge, skills, and tools to perform this type of work safely and effectively. If you are not comfortable performing this work yourself, it is recommended to consult with a professional mechanic.
