1. Park the car on a level surface and apply the parking brake.
2. Chock the front wheels to prevent the car from rolling.
3. Jack up the rear of the car until the wheels are off the ground.
4. Locate the brake caliper on the rear of the wheel hub.
5. Use a 13mm wrench to loosen the two bolts holding the caliper in place.
6. Once the bolts are loose, slide the caliper off the rotor.
7. Inspect the brake pads for wear. If they are less than 2mm thick, they should be replaced.
8. If the brake pads are in good condition, use a C-clamp to compress the piston back into the caliper.
9. Slide the caliper back onto the rotor and tighten the bolts.
10. Remove the jack stands, lower the car to the ground, and release the parking brake.
11. Test the brakes before driving the car.
