1. Safety Precautions
- Ensure that the vehicle is in a safe position, with the parking brake on and the engine turned off.
- Use appropriate personal protective equipment, such as gloves and safety glasses.
2. Remove the Wheel
- Loosen the lug nuts on the affected wheel before lifting the vehicle.
- Lift the vehicle with a floor jack or ramps and remove the affected wheel.
3. Remove the Brake Caliper
- Locate the brake caliper bolts and remove them.
- Gently pry the brake caliper off the rotor and hang it safely out of the way with a hanger or bungee cord.
4. Remove the Brake Disc
- If necessary, remove the brake disc by unscrewing the retaining screws.
5. Remove the Hub Nut and Bearing
- Locate the hub nut and remove it using a breaker bar and a socket wrench.
- Use a hub puller to remove the bearing from the hub.
6. Inspect the Hub
- Inspect the hub for any damage or excessive wear. Replace it if necessary.
7. Install the New Hub
- Place the new hub onto the spindle.
- Install the hub nut and tighten it to the specified torque.
8. Reinstall the Brake Disc
- If the brake disc was removed, reinstall it and secure it with the retaining screws.
9. Reinstall the Brake Caliper
- Place the brake caliper back over the rotor and secure it with the bolts.
10. Reinstall the Wheel
- Place the wheel back on the hub and tighten the lug nuts.
11. Lower the Vehicle
- Carefully lower the vehicle back to the ground.
- Tighten the lug nuts using a torque wrench to the specified torque.
12. Test Drive
- Take the vehicle for a brief test drive to ensure that the wheel hub and brakes are functioning properly.
Remember that this general overview of the process. Refer to your vehicle's specific service manual for detailed instructions and torque specifications for your model. If you lack experience working with brakes and wheel hubs, consider seeking professional assistance from a qualified mechanic.
