Tools and Materials Needed:
- Replacement wiper motor (compatible with your Peugeot Boxer van)
- Socket wrench set
- Phillips head screwdriver
- Flat head screwdriver
- Pry tool or plastic spudger
- A funnel and some fresh windshield washer fluid
Step-by-Step Guide:
1. Park Safely:
- Make sure your Peugeot Boxer van is parked in a safe and level area. Turn off the engine and apply the parking brake.
2. Locate Fuse Panel:
- Locate and open the fuse panel inside the vehicle. Remove the fuse responsible for the wiper motor to disable power to the system. This step ensures safety while working on the wiper motor.
3. Remove Wiper Arms:
- Lift the hood of your van. Locate the wiper arms and remove the wiper blades by lifting them off the windshield.
- Once the wiper blades are removed, use a socket wrench to loosen and remove the nuts or bolts that secure the wiper arms to the linkage. Carefully remove the wiper arms from the vehicle.
4. Remove Cowling:
- Locate and remove the plastic cowling that covers the base of the windshield and wiper assembly. This part is held on with plastic clips or screws, and it needs to be removed to access the wiper motor.
5. Unplug Wiring Harness:
- Once you have removed the cowling, you can see the wiper motor. Locate and disconnect the wiring harness that connects the wiper motor to the vehicle's electrical system.
6. Remove Bolts:
- Use a socket wrench to remove the bolts that secure the wiper motor to the vehicle's firewall or mounting brackets.
7. Replace Wiper Motor:
- Remove the old wiper motor by pulling it out of the housing. Be careful not to damage any components nearby.
- Install the replacement wiper motor by aligning it with the mounting brackets or studs. Secure it using the bolts you removed earlier.
8. Reconnect Wiring Harness:
- Reconnect the wiring harness to the new wiper motor. Ensure the connection is secure.
9. Test Motor:
- Before reassembling the cowling and wiper arms, test the wiper motor by turning on the ignition. Operate the wiper switch and verify that the wiper motor works correctly.
10. Reassemble Components:
- Reattach the cowling by pushing it into place and securing it with the clips or screws you removed earlier.
- Reinstall the wiper arms by aligning them with the linkage and securing them with the bolts or nuts you removed initially.
- Replace the wiper blades onto the wiper arms.
11. Refill Windshield Washer Fluid:
- Open the windshield washer fluid reservoir and refill it if needed. Use a funnel to prevent spillage.
12. Test Wiper System:
- Turn on the ignition and test the wiper system again to ensure it is functioning properly.
Remember, if you are unsure or uncomfortable performing these steps, it's best to seek professional assistance from a qualified mechanic to ensure the safety and proper installation of the wiper motor.
