1. Disconnect the Battery:
Before starting any electrical work, disconnect the negative battery terminal to prevent any electrical accidents.
2. Remove the Dashboard Trim:
- There might be a plastic cover or trim around the headlight switch. Use a plastic pry tool to carefully remove the trim pieces to expose the screws securing the switch.
3. Locate the Headlight Switch:
- Once the trim is removed, you should see the headlight switch. It's usually located on the left side of the dashboard.
4. Disconnect Electrical Connectors:
- There should be electrical connectors plugged into the back of the headlight switch. Gently press the tabs on the connectors and pull them out. Be cautious not to damage the connectors or wires.
5. Remove the Headlight Switch:
- After disconnecting the electrical connectors, remove the screws holding the headlight switch in place. Be mindful of any small parts, like washers or clips, that might fall out.
6. Install the New Headlight Switch:
- Place the new headlight switch into position and secure it with the removed screws.
7. Reconnect Electrical Connectors:
- Plug the electrical connectors back into the new switch, ensuring a secure connection.
8. Test the Headlights:
- Reconnect the battery terminal and turn the ignition key to the "ON" position. Verify that the headlights turn on and off when operating the new headlight switch.
9. Replace the Dashboard Trim:
- Reattach the dashboard trim or cover that you removed earlier.
10. Test Drive:
- Take the motorhome for a short drive to ensure that the headlights work correctly and that there are no issues with the electrical system.
11. Enjoy the Restored Headlights:
- You have now successfully replaced the headlight switch in your 1998 Bounder motorhome. You can now enjoy properly functioning headlights during your travels.
Remember, if you're uncomfortable working with electrical components, it's best to seek professional assistance to ensure a safe and accurate replacement.
