1. Disconnect the battery negative terminal.
2. Remove the glove compartment door. There are three screws holding it in place.
3. Locate the blower motor resistor. It is located behind the glove compartment, on the passenger side of the car.
4. Remove the two screws holding the resistor in place.
5. Disconnect the electrical connector from the resistor.
6. Install the new resistor.
7. Reconnect the electrical connector.
8. Tighten the two screws holding the resistor in place.
9. Reinstall the glove compartment door.
10. Reconnect the battery negative terminal.
