Contents
1. Introduction
2. Safety Precautions
3. Tools and Materials
4. Troubleshooting
5. Disassembly
6. Component Repair
7. Reassembly
8. Testing
Introduction
The Kenmore dishwasher model 665-15999-400 is a top-loading dishwasher with a stainless-steel finish. It has a capacity of 14 place settings and features a variety of wash cycles, including a heavy-duty cycle, a normal cycle, and a light cycle. The dishwasher also has a built-in water softener and a delay start feature.
Safety Precautions
Before beginning any repairs, be sure to disconnect the dishwasher from the power supply. You should also wear gloves and eye protection to avoid injury.
Tools and Materials
The following tools and materials are required to perform repairs on the Kenmore dishwasher model 665-15999-400:
* Phillips-head screwdriver
* Flat-head screwdriver
* Nut driver
* Adjustable wrench
* Pliers
* Wire cutters
* Electrical tape
* Replacement parts (if necessary)
Troubleshooting
Before beginning any repairs, it is important to troubleshoot the problem to determine the cause. The following are some common problems with the Kenmore dishwasher model 665-15999-400:
* The dishwasher is not turning on.
* The dishwasher is not filling with water.
* The dishwasher is not draining properly.
* The dishes are not getting clean.
* The dishwasher is making a strange noise.
If you are experiencing any of these problems, refer to the troubleshooting section in the repair manual for possible solutions.
Disassembly
If the troubleshooting section does not help to resolve the problem, you may need to disassemble the dishwasher to perform repairs. The following are the steps required to disassemble the dishwasher:
1. Remove the screws that hold the top panel in place.
2. Lift the top panel off of the dishwasher.
3. Remove the screws that hold the control panel in place.
4. Lift the control panel off of the dishwasher.
5. Remove the screws that hold the door in place.
6. Lift the door off of the dishwasher.
7. Remove the screws that hold the lower panel in place.
8. Lift the lower panel off of the dishwasher.
Component Repair
Once the dishwasher is disassembled, you can begin repairing the components that are causing the problem. The following are some common components that may need to be repaired:
* The water inlet valve.
* The water pump.
* The heating element.
* The drain pump.
* The timer.
If you are not comfortable performing repairs yourself, you can contact a qualified appliance repair technician to help you.
Reassembly
Once the repairs are complete, you can reassemble the dishwasher by following the steps in reverse order.
Testing
After the dishwasher is reassembled, test it to make sure that it is working properly. Run the dishwasher through a complete cycle and check for leaks, unusual noises, or other problems.
Note
The information in this repair manual is provided for informational purposes only. It is not intended to be a substitute for professional advice. If you are not comfortable performing repairs yourself, you should contact a qualified appliance repair technician.
