1. Park your car on a level surface and apply the hand brake.
2. Locate the hand brake adjuster, which is usually located under the center console or near the hand brake lever.
3. Use a screwdriver or other suitable tool to turn the adjuster clockwise to tighten the hand brake cable or counterclockwise to loosen it.
4. Test the hand brake by releasing it and then applying it again. The hand brake should hold the car in place without the need to apply excessive force.
5. Repeat steps 3 and 4 until the hand brake is adjusted to your desired level of tightness.
6. Make sure the hand brake is not too tight, as this can cause the brake pads to wear out prematurely.
It's important to note that adjusting the hand brake is a safety-critical task, and if you are not confident in your ability to perform it correctly, it is best to have it done by a qualified mechanic.
