* 3/8-inch drive ratchet
* 3/8-inch drive torque wrench
* 5/16-inch allen wrench
* 1/2-inch drive breaker bar
* 1/2-inch drive torque wrench
* 5/8-inch allen wrench
* Drive belt installation tool
* Rags
* Safety glasses
Procedure:
1. Put the transmission in neutral and turn the ignition off.
2. Remove the seat.
3. Remove the transmission drain plug and allow the oil to drain into a suitable container.
4. Remove the derby cover by removing the four 5/16-inch allen bolts.
5. Remove the outer primary cover by removing the eight 1/2-inch allen bolts.
6. Use a rag to clean any dirt or debris from the outer primary housing and the derby cover.
7. Remove the old drive belt by prying it off the pulleys with a pry bar. Be careful not to damage the pulleys or the surrounding components.
8. Slide the new drive belt around the rear pulley first, then the front pulley, and align it with the teeth on the pulleys.
9. Use the drive belt tool to slowly pry the new drive belt up into position, alternating between the front and rear pulleys.
10. Install the derby cover and the outer primary cover, and tighten the allen bolts to the specified torque.
11. Tighten the transmission drain plug to the specified torque.
12. Refill the transmission with oil.
13. Start the engine and check for any leaks.
*The above procedure is a general guide, and the specifics may vary depending on the model and year of your Harley.**
