1. Disconnect the negative terminal of the battery.
2. Remove the transmission covers.
3. Remove the clutch slave cylinder.
4. Remove the starter motor.
5. Remove the flywheel housing bolts and remove the clutch housing.
Step 2: Remove the old clutch disc and pressure plate.
1. Remove the clutch disc bolts and remove the clutch disc.
2. Remove the pressure plate bolts and remove the pressure plate.
Step 3: Install the new clutch disc and pressure plate.
1. Install the new clutch disc onto the flywheel, aligning the splines of the disc with the splines on the flywheel.
2. Install the new pressure plate onto the flywheel and hand-tighten the pressure plate bolts.
3. Tighten the pressure plate bolts evenly and in a crisscross pattern to the specified torque.
4. Make sure there is some play in the release lever.
Step 4: Reinstall the clutch housing and transmission covers.
1. Reinstall the clutch housing and install the clutch housing bolts.
2. Reinstall the transmission covers
3. Reconnect the negative terminal of the battery.
Step 5: Test the clutch.
1. Start the tractor.
2. With the tractor in gear and your foot off of the clutch pedal, the tractor should not move.
3. Press down on the clutch pedal and the tractor should move.
